Primera Bravo XR User Manual download pdf (Page 69)

Maintenance and Troubleshooting 65

Section 6: Maintenance and

Troubleshooting

The Publisher is designed to operate for extended periods of

time with very little attention. In fact, no regular maintenance

is recommended other than cleaning the outside case.

NOTE: Do NOT attempt to oil or grease the Publisher's Robotic Arm shaft

or other components. You will likely cause more harm than good!

Any moving parts are designed to operate for the life of the machine

with no additional lubrication required.

A. CLEANING THE PUBLISHER

Use a clean, lint-free rag with a small amount of ammonia

window cleaner to clean the Publisher's outside case and

trays. This type of cleaner is very effective on inks that may

accumulate on the printer tray. Stronger cleaning solutions are

NOT recommended because they may damage the paint and

plastic materials from which the parts are manufactured.

Always disconnect your Publisher's power cords before

cleaning. Resume operation only after the surfaces are

completely dry.

B. PERFORMING A ROBOTIC SELF-TEST

To ensure that everything is working properly, a Self-Test

feature is built in to your Publisher. In this mode, the Robotic

Disc Transporter will go through the motions of picking and

placing a disc to ensure proper working order. This test may be

performed without connecting the Publisher to the PC.

Perform the test by doing the following steps:

• Load some discs into the Input Bin

• The cover must be closed for this operation to complete.

However, in order to access the buttons you must open the

cover. To get around this problem simulate closing the

cover by activating the cover lock sensor. You may do this

by putting an object such as a folded piece of paper in the

slot where the lock would normally be located.

510951new.qxd 5/8/2006 10:51 AM Page 65

TOC

INDEX

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 75 76 77

No comments

Primera Bravo XR User Manual Page 69